Servomex Servotough SpectraScan 2400, Руководство пользователя

Страница: 16 / 76

SERVOTOUGH SpectraScan User Manual
02400001A/1 14
USE THE PROPER FUSE
Use only a fuse of the correct type, voltage rating, and current rating, as specified for your product.
See Table 13 - Electrical Specifications on page 72 and
Figure 6 - SpectraScan Interior Diagram
on page 33 for more information.
DO NOT OPERATE IN EXPLOSIVE ATMOSPHERES
To avoid explosion, do not operate this product in an explosive environment unless it has been
specifically certified for such operation. If it has been certified for such operation, carefully follow
the guidelines set forth in the Material Safety Data Sheets for the explosive chemical, as well as the
product labelling on the Servomex SpectraScan Gas Analyzer.
HIGH VOLTAGE DANGER
Assume high voltage is present in the cable and in the analyzer whenever a power cord is
connected.
USE PROPER FITTINGS AND TIGHTENING PROCEDURES
All connection fittings must be consistent with Servomex SpectraScan Gas Analyzer specifications,
and compatible with the intended use of the unit. Assemble and tighten fittings according to
manufacturer's directions. See Section 5.0.5 Fittings Requirements on page 26 for more
information.
CHECK FOR LEAK-TIGHT FITTINGS
Carefully check all connections to ensure leak-tight installation.
OPERATE AT SAFE INLET PRESSURES
Never operate at pressures higher than the rated maximum and minimum pressure. See Section
3.4.3 Over Pressurizing on page 18 and Table 11 - Sampling System Specifications on page 71 for
more information.
KEEP THE UNIT FREE OF CONTAMINANTS
Do not allow contaminants to enter the unit before or during use. Contamination such as dust, dirt,
lint, glass chips, or metal chips may permanently damage the unit.