SENS EnerGenius® DC Compact Technical Manual
39
Sched Batt Check
Adjust amount of time between
scheduled Battery Check tests from 1 to
90 days
Next Sched Batt Check
View time until next scheduled Battery
Check test
Service Tools
Relay Test
Press UP arrow to set all alarm relays
and DOWN arrow to clear all relays
Display Test
Press UP arrow to set all LCD segments
black and DOWN arrow to clear all LCD
segments
UI Access Control
Select allowed user interface access.
Access options include read-
only/monitor viewing or full access
adjustments for advanced users.
Change Security Code
Change security code to desired 6 digits.
The default security code is 000000
(disabled). Upon entering a security
code, the display will automatically
prompt user for the code to access
protected menus. Menus are protected
depending on configured level of access
(see UI Access Control definitions
above).
Relock Access
Exit Service Mode and relock access
I-O Bus Settings
TCP/IP Settings
TCP-IP Address
Set TCP-IP Address
TCP-IP Gateway
Set TCP-IP Gateway
TCP-IP Subnet Mask
Set TCP-IP Subnet Mask
Hardware Mask
Reads Hardware Address (MAC address
of the unit)
I-O Bus Settings
Modbus RS485
Modbus Configuration
Select RTU or set to OFF to disable
Modbus communications.
Modbus Configuration Address
Adjust Modbus slave address from 1 to
255. Set to OFF to disable Modbus
communications.
Modbus Configuration Parity Bit
Set Modbus parity to none, even or odd
Modbus Configuration Baud Rate
Adjust Modbus baud rate, 57.6 Kbps
maximum
Modbus Configuration Write
Enable or disable write access via
Modbus
I-O Bus Settings
Modbus TCP
Modbus Configuration
Enable or disable Modbus TCP-IP
Modbus Configuration Address
Adjust Modbus slave address from 1 to
255. Set to OFF to disable Modbus
communications.
Modbus Configuration Write
Enable or disable write access via
Modbus
SENSnet
SENSnet Mode
Enable or disable SENSnet Mode. When
disabled the charger will not
communicate via IP address. Enabled by
default.
Unit Information
Serial No.
Charger serial number
