SENKO pellet WATER+AIR stoves
–
Instruction manual
39
5.4.
REMOTE CONTROL
The remote control allows you to regulate the heating power, speed of
warm air ventilator and stove activation and deactivation. When used, the
remote control must ALWAYS be directed toward the infrared receiver on
the control panel (
figure 20
).
Keep the remote control away from direct sources of heat and water!
Keep the remote control away from children!
It may happen that the remote control of another device (TV, radio ...) is
on the same frequency as the remote control of your stove. In this case,
the function of the stove remote control must be switched off!
Prior to
remote control
initial use, the
protective foil must be removed
from
the back side (see
figure 21b
). If you wish
to replace empty battery, it is necessary to
pull out the battery holder (as shown in
figure 22
) on the back side of the remote
control and change the battery in
accordance with the symbols displayed on it.
3V Lithium CR2025
battery is
used in the remote control.
Adjusting warm air
ventilator speed (1-5)
Adjusting heating
power (1-5)
Setting warm air
ventilator speed (
not
operating mode!
) to
automatic mode
(
depending on heating
power
)
Turning the stove ON
Turning the stove OFF
Figure 21a
Figure 21b
Содержание P 12 SLIM WATER+AIR
Страница 14: ...SENKO pellet WATER AIR stoves Instruction manual 13 Figure 1 P 12 WATER AIR P 12 WATER AIR BOX...
Страница 15: ...SENKO pellet WATER AIR stoves Instruction manual 14 P 12 SLIM WATER AIR P 20 WATER AIR Figure 1...
Страница 17: ...SENKO pellet WATER AIR stoves Instruction manual 16 4 INSTALLATION 4 1 RECOMMENDATIONS Figure 3...