SENKO P 12 SLIM WATER+AIR, Инструкция по эксплуатации, Страница: 37 / 80

SENKO pellet WATER+AIR stoves
–
Instruction manual
36
During the heating and cooling periods the stove material is exposed
to expansion and contraction which may result in light cracking
sounds . This occurrence is perfectly normal since the stove is constructed
of steel sheets and should therefore not be considered a malfunction.
Do not use any flammable liquids to ignite the pellets !
Prior to activating the stove, check the following :
pellet tank must be loaded with pellets ,
the firebox must be clean ,
burner pot must be clean and empty ,
make sure you properly install it back into the casing
–
Figure 39a ,
make sure that the firebox door are hermetically closed ,
make sure that the power cable is properly connected ,
backside switch must be set to 1 .
It is of the utmost importance
not to increase the heating power to
maximum already in the beginning; increase the power gradually
instead. In manual mode use lower heating levels (e.g. fire 1-2-3). After
several minutes you can use the remaining available heating levels ( fire 4-
5), BUT keep in mind that the stove may operate on maximum (nominal)
power up to 3 h. In this manner, damages that may occur on construction
materials are avoided.
After longer periods of inactivity, all pellet residues must be vacuumed
from the tank due to the fact that they can absorb moisture which alters
their original properties, making them unsuitable for combustion and
transport to the firebox.
It is MANDATORY that before first ignition you make the calibration
or pellet feeder correction according to Chapter 5.9.2. and Table 12.
In case of power failure, and when power returns, the flue gas fan will
work with its maximum speed to extract the remaining smoke from the
firebox. The display will show "SHUT DOWN". After this process is
complete and the stove reaches the state OFF, you must manually
turn on the stove by pressing the ON/OFF key ( for the duration of 2 sec ).