Basic Rider Optimization Training for the Segway
HT
Page 79 of 106
Instructor Guide and Participant Workbook
Rev 3.5i - January 2004
© Segway LLC 2002
P/N 1707100001aa
Replacing a Parking Stand (i Series only)
Tools Required:
4mm hex wrench, T-15 or T-20 six lobed wrench (depending on fastener size),
16mm socket wrench, alcohol wipes, plastic or rubber mallet, torque wrench
Before you begin:
Tip the Segway HT onto its side so that the outside
of the left wheel lays flat against a clean smooth
surface.
Directions:
1. Remove the Tire/Wheel Assembly—See
“Replacing a Tire/Wheel Assembly” on
page 76.
2.
Remove the Fender—See “Replacing the
Fender” on page 78.
Parking Stand Removal Instructions
3.
Remove the two Parking Stand screws using a
4mm hex wrench.
4.
Disengage the Parking Stand lever from the
Mat.
5.
Remove the Parking Stand.
Replace any fasteners you remove when
performing this installation with the new
fasteners included in the replacement kit
Parking Stand Installation Instructions
6. Set the new Parking Stand on the side
of the Chassis.
7. Align the two screw holes (ensuring
that the Parking Stand bracket is flush
against the Chassis).
8. Thread in the two new hex head
screws and torque to 0.5 N-m with a
hex wrench (do not over tighten).
9. Install the Fender— See “Replacing the
Fender” on page 78.
10. Install the Tire/Wheel Assembly— See
“Replacing a Tire/Wheel Assembly” on
page 76.
11. Tip your Segway HT up onto its wheels
and test the operation of the new
Parking Stand.