4
|
TBA Evaporative Cooler
SAFETY NOTES
SAFETY NOTES
cont.
Please read this manual carefully. Your failure to do so
could result in injury to you or damage to the cooler and
property.
Disconnect electrical power at the fuse or circuit breaker box
and turn “OFF” the isolating switch located inside the cooler on
the Electronics Module before you begin to install the cooler.
Always comply with your local laws and safety regulations.
INSTALLATION & OPERATION
• Installation of the cooler must comply with local electrical,
water supply and environmental codes, laws and safety
regulations as well as with applicable National Standards.
• Dress safely. Wear non-slip shoes at all times. Open shoes,
sandals and bare feet are NOT safe when working with tools
and machines. Do not wear loose clothing and decorations
while installing the cooler as they can get caught in the
moving parts.
•
Keep long hair, loose clothing and fingers away from moving
parts.
• Do not install the cooler during rain, high winds, or severe
weather conditions.
• This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children
without supervision.
• Wear protective clothing when working with power tools.
• Always ensure that electrical power cables conform to
relevant government safety requirements.
• Always lift the cooler to its location using safe methods and
equipment.
• Never drain the cooler directly onto the roof. Always use pipes
to carry the drain water to a proper point. Failure to do this
can stain the roof and make the roof slippery and unsafe.
• All installation, maintenance and repair work must be done by
trained and qualified technicians.
• The plastic packaging from the cooler can be a safety hazard.
Please dispose of it in accordance with local laws and
regulations.
OTHER IMPORTANT REQUIREMENTS
Never force parts to fit because all parts are designed to fit
together easily without undue force.
Never drill any holes in the primary base surface or side walls of
the bottom tank (reservoir) of the cooler.
Check the proposed cooler location, to ensure that it is
structurally capable of supporting the weight of the cooler, or
provide an adequate alternate load bearing structure.
ALWAYS route cables at least 300mm away from regular power
cables and high power machines. Cross over power cables at
right angles.
Where maximum data cable and sensor cable lengths are
exceeded, or cables are not routed in accordance with our
recommendations Seeley technical support is not available and
the product warranty may be voided.
If the supply cord is damaged, it must be replaced with a special
cord available from the manufacturer or its Service Agents,
and must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Do not operate any cooler with a damaged cord or plug
