14
|
TBA Evaporative Cooler
ILL1293-A
ILL1135-C
ILL1063-A
INSTALLING THE WALL CONTROL
PLASTER BOARD OR BRICK WALL
To mount the wall control on a plaster board or brick wall, use
the template provided and drill the 16mm hole for the wall
control cable and the (5mm Plasterboard or 6mm Brick) holes
for the mounting plugs.
WALL CONTROL LOCATION
Install the Wall Control station about 1.5 metres above the floor
in the place where you want the temperature to be controlled
from.
When selecting a position for the Wall Control station avoid the
following locations:
• Direct sunlight.
• Outside walls.
• Any heat sources.
• A position in direct line of a cooling outlet.
Mounting the wall control in a position near any heat source or
cooling outlet will affect its ability to control temperature.
The Wall Control cable will plug into the back of the Control.
Note!
For brick walls, position the template so the screw and
cable holes are not located into the mortar between the bricks.
WARNING!
Ensure there are no electrical wires behind the wall
where you intend to drill.
Insert the mounting plugs into the holes and ensure the plug
face is against the wall.
Position the wall plate over the screw holes and secure the top
screw. Align the wall plate vertically and secure with the lower
screw.
Check alignment and tighten the screws.
2 x 5mm / 3/16” (Plasterboard)
or 2 x 6mm / 1/4” (Brick)
16mm / 5/8”
65mm / 2.55”
31mm / 1.22”
