Security Brands Edge 27-210, Руководство по прямому программированию

Страница: 78 / 80

Direct Programming Manual
Edge
Smart Keypads and Card Readers
74

If you need help, please email techsupport@securitybrandsinc.com or call (972) 474-6390 .
Enter Master Code (default 1251) and listen for good tone.
Enter sub mode 8 and listen for good tone.
Enter 1 for use restriction or 2 for time restriction and listen for good tone.
Enter the code with configured length and listen for good tone.
Enter number of uses (01 to 99) or number of hours (01 to 24).
Enter # key to exit Programming Mode.
Enter Pairing Mode
This procedure will start a 90-second timer for first-time administrator pairing with the Edge unit.
1251
$
9
$
1
$
#
Enter Master Code (default 1251) and listen for good tone.
Enter sub mode 9 and listen for good tone.
Enter 1 and listen for good tone.
Enter # key to exit Programming Mode.
Delete All Codes and Timers
This procedure will delete all codes and timers.

IMPORTANT! COMPLETING THIS PROCEDURE WILL DELETE ALL CODES AND TIMERS!
1251
$
0
$
1251
$
#
Enter Master Code (default 1251) and listen for good tone.
Enter sub mode 0 and listen for good tone.
Enter Master Code again and listen for good tone (wait until good tone is received).
Enter # key to exit Programming Mode.
Master Code Reset
This procedure will reset the Master Code to the default value. No other stored data is affected.
Open faceplate on unit.
Locate, press, and hold down Factory Reset (Fac. Rst.) button on main circuit board (located
near front-left corner of circuit board and below Wiegand 1 screw terminals).
While still holding Factory Reset button, press star (*) key 3 times on Edge unit keypad and
listen for good tone.
Release Factory Reset button.
The Master Code is now set to the default value (1251).