Revision 22 13.10
7
SECTION 2
INSTALLATION
CAUTIONS
Your vendor is intended for indoor use only.
Excessive heat, cold or humidity levels will void your warranty; install only in climate
controlled, indoor environments. For indoor machines the temperature range must be no
higher than 32°C/90°F and no lower than 10°C/50°F with a relative humidity (Rh)level of
no greater than 40%.
Your vendor must be set on a level, well-supported location.
Always unload vendor before transporting it.
Remove all wire ties and protective sheeting prior to vending.
CAUTION!
It is important that this machine is hooked up to the proper voltage. Verify the voltage
before connecting the machine to a wall outlet.
CAUTION!
Different countries may have different power arrangements. Insure that the machine is
properly grounded before operating.
CAUTION!
If the power cord is damaged, it must be replaced by the manufacturer, authorized service
agent or a similarly qualified person to avoid electrical hazards.
ATTENTION!
This vending machine is very heavy. Ensure that sufficient personnel are available for
lifting or transporting the machine. Use proper lifting procedures and equipment.
CAUTION!
Certain components of this machine are sensitive to static electricity. Precautions for
handling sensitive devices should be observed when handling these items.
ATTENTION!
Refrigerated models need air flow. Leave at least 6” (15 cm) between the back of the
vending machine and the wall. Condenser cooling air is taken in the bottom and
exhausted out the back of the machine. Clean the condenser once every two weeks or
more often for dusty or dirty locations.
