29
If there is no manual mode available for the pop-up flash, set Prelamp Copy to ON
and if required, adjust Prelamp Time to a value close to the one on the camera in use.
With the correct setting, the strobe will be able to copy the camera prelamp properly
and then give the desired output of manual power at the exposure lamp.
3. Optical Stroboscopic Mode
With an optical cable connected the auto stroboscopic time is not available and the
desired time has to be set up from the dedicated set up line.
For more info on the
Stroboscopic Mode, please refer back to page 21.
4. Optical Dual / Multiple Flash Operation
More than one unit can be connected to a single camera in fiber optic mode OC.
Each unit has to be set up in order to meet the individual requirements.
For more info
please refer back to page 25/26.
5. Front Slave Sensor
When front slave input
SL
is selected, the flash is triggered by the slave sensor (8)
placed inside the reflector. This sensor is very sensitive and allows working distances
of up to 10 meters between the master and the slave. However, this distance largely
depends on the clearness of the water.
Information
Shooting is possible
only in manual mode
– regardless of the TTL position of
power switch (1). The desired power level can be selected with the rotary switch (2).
Shooting Mode – Optical Cable & Front Slave Sensor
