13
In
TTL
mode, correct the exposure if /- with the rotary switch (2) 1/3
aperture per step.
In
MAN
manual mode, adjust the power setting with the rotary switch (2) – increasing
the power rotating clockwise and decreasing the power rotating counterclockwise.
Half aperture per step.
Multiple flash operation
If more than one unit has to be connected to the camera
with a cable connection,
set the main strobe to MASTER MODE and all the other flashes to SLAVE MODE.
To select SLAVE mode, enter SET with the power switch (1), select MASTER / SLAVE
set up with the rotary switch (2), activate it with push button (3), set it to SLAVE with
rotary switch (2) and confirm it with push button (3). The unit will then reboot in
SLAVE mode. When in SLAVE mode, an
s
appears on the display after the
CB
label:
CBs
– it identifies the SLAVE units.
Feature
All flash settings are stored in the internal memory and have to be set only once.
If a
cable connection
is used to synchronize the strobe with NIKON or CANON
cameras the system is fully ready to start, no other adjustments are required. CB will
be shown automatically in the display when the camera is connected and activated.
If a
fiber optic cable
is used to synchronize the strobe, maybe an additional set up
could be required once – due to a great number of possible combinations of different
hardware. If this is the case, please refer to the specific chapter in this manual (9) and
the manual of the camera used.
Quick Guide
