12
The SEAFLASH 160
digital
is easy to set up and use with only a few steps.
Macro protection ring and M8 Ball Adapter
For macro photography, leave the macro protection ring (14) on the unit to reduce the
light angle to approximately 90°. For the required illumination of wide-angle lenses,
remove the macro protection ring (14) from the fl ash by turning it to the left. When
installing, make sure that the protection ring snaps into the correct position by turning
it over the resistance so that it cannot be lost.
An M8 ball adapter is required to attach a fl ash arm to the fl ash unit. Use the original
SEACAM M8 ball adapter (not included) – it is mounted onto the M8 connection thread (13).
ATTENTION!
If you are using balls from other manufacturers on the fl ash unit, make sure that
the thread of the ball is no longer than 7 mm. Longer threads can cause massive
damage to the housing.
Single fl ash operation
1.
Fit a fully charged battery in the battery compartment and close it with the cap.
2.
Connect the fl ash to the camera by wire or optical cable at the S6 synchro (11)
or fi ber optic socket (12)
3.
Set the power switch (1) to TTL, powering up the strobe.
4.
Select desired fl ash input mode: press push button (3) for 2 seconds to
switch between sync inputs:
CB
Cable
OC
Optical Cable
SL
Front Slave Sensor
5.
Select Shooting
Mode
with power switch (1)
TTL
TTL mode
MAN
Manual mode
MOD
Stroboscopic mode
Quick Guide
ATTENTION!
If you are using balls from other manufacturers on the fl ash unit, make sure that
the thread of the ball is no longer than 7 mm. Longer threads can cause massive
damage to the housing.
