SEA SYSTEMS
INSTALLATION AND USE
STK1R control panels (Setronik1 Restyling)
STK1R-EN-62-0-A
rev0
24/01/2019
5.6.1. S
HAFT
SYSTEM
VC01
System made up of magnetic sensors (reed switches). Used for electric and hydraulic lifts.
K
D
, K
S
= S
LOWDOWN
DISTANCES
These distances depend on the speed of the lift and the technical characteristics of the motor or
the hydraulic unit installed.
If
K
D
+ K
S
+ 5
CM
>
minimum distance between adjacent floors
, it is necessary to install the
VEN01 encoder shaft system.
© 2019
Sea Systems
Page 12 of 99
FRONT VIEW
CAR ROOF VIEW
Sensor
Function
SIS
Monostable reed switch for
ascending stop control and
ascending speed change
control
SID
Monostable reed switch for
descending stop control and
descending speed change
control
SRS
Bistable reed switch for
speed change control at
uppermost landing
SRD
Bistable reed switch for
speed change control at
lowest floor and position reset
SIZ1, SIZ2
Monostable reed switches for
controlling CS4 safety circuit
(*)
(*) The CS4 safety circuit is necessary in
the following cases:
- amendment A3
- hydraulic/electric relevelling
- early door opening