Sea Tel 9711-92, Инструкция по установке и эксплуатации

Страница: 50 / 196

Installation 9711-92 Ku-Band TXRX
3-28
3.5.4. Installing the Below Deck Equipment
1. Install the ACU in the front of the standard 19” equipment rack or other suitable location. The DAC-
2202 ACU is one rack unit high.
2. Install the Terminal Mounting Strip on the rear of the 19” equipment rack or other suitable location
that is within 6 feet of the rear panel connections of the ACU. It also is one rack unit height.
3. Install the Base Multiplexer Panel on the rear of the 19” equipment rack or other suitable location
that is within 6 feet of the rear panel connections of the ACU. It is four rack unit height.
4. Install the Line Amplifier Panel on the rear of the 19” equipment rack or other suitable location that
is within 6 feet of the Base Multiplexer Panel. It is four rack unit height.
5. Install your Satellite Modem, Router, VOIP adapters, Telephone equipment, Fax machine, Computers
and any other below decks equipment that are part of your installation.
3.6. Connecting the Below Decks Equipment
Connect this equipment as shown in the System Block Diagram. Install the equipment in a standard 19 inch
equipment rack or other suitable location. Optional slide rails are available.
3.6.1. Connecting the ADE AC Power Cable
Connect the AC Power cable that supplies power to the ADE to a suitably rated breaker or UPS.
3.6.2. Connecting the BDE AC Power Cables
Connect the AC power cables that supply power to the Below Decks Equipment (ACU, satellite modem,
phone, fax, computer and all other equipment) to an outlet strip fed from a suitably rated breaker or UPS.
3.6.3. Connecting the ADE IF Coaxes
1. Attach the TXIF coax from the antenna to a shorter section of coax to reach the TX Output of the
Diplexer Box, inside the ship but near the antenna. Then attach the long section of coax (200 feet
min) coax from the TX Input of the Diplexer Box, to the TX Connector on the Base Multiplexer
Panel.
2. Attach the RXIF coax from the antenna to a shorter section of coax to reach the RX Output of the
Diplexer Box, inside the ship but near the antenna. Then attach the long section of coax (200 feet
min) coax from the RX Input of the Diplexer Box, to the RX Connector on the Base Multiplexer
Panel.
3.6.4. Connect the Modem TXIF Coax
Connect the TXIF coax from the Base Multiplexer Panel to the Satellite Modem TX Output.
3.6.5. Antenna Control Unit Connections
Figure 1-2 Rear Panel DAC-2202 ACU
3.6.5.1. Antenna Control Serial Cable
Connect the antenna control serial cable from the Base Multiplexer to J4A on the DAC-2202.
3.6.5.2. ACU to Terminal Mounting Strip Connections
Connect the TMS to the ACU.
1. Connect the 25 pin ribbon cable from the TMS to J1 “Ships Gyro” DB25 on the rear
panel of the ACU.
2. Connect the 9 pin ribbon cable (or NMEA serial cable) from the TMS to J2 “NMEA”
DB9 on the rear panel of the ACU