Sea Tel 9711-92, Инструкция по установке и эксплуатации

Страница: 87 / 196

9711-92 Ku-Band TXRX Setup – Modem Connections, Setup and Test
12-3
12.4. Hughes Modems
Terminal Mounting Strip Jumpers:
JP1 = Open
JP2 = Shorted
JP3 = Open
JP4 = Open
JP5 must be set to 12VDC
JP6 = Shorted
Model Lock output Mute input Recommended
SYSTEM TYPE GPS Input
HX-150 HIGH = Lock HIGH to Mute 215 GLL string
HX-200 HIGH = Lock HIGH to Mute 215 GLL string
12.5. STM Modems
Terminal Mounting Strip Jumpers:
JP1 = Open
JP2 = Shorted
JP3 = Open
JP4 = Shorted
JP5 must be set to 24VDC
JP6 = Shorted
Model Lock output Mute input Recommended
SYSTEM TYPE
GPS Input
SatLink 2000 LOW = Lock LOW to Mute 7 GLL string
12.6. Connections (ACU to Satellite Modem)
12.6.1. iDirect Modems
Infinity 3100 - Use an RJ-45 straight serial cable connected from the Terminal Mounting Strip “Console Port”
connector to the Console Port connector on the rear panel of the modem.
Infinity 5100 - Use an RJ-45 straight serial cable connected from the Terminal Mounting Strip “Console Port”
connector to the Console Port connector on the rear panel of the modem.
12.6.2. Comtech Modems
Connect the 126877 harness assembly from the 15 pin serial port on the 570L or 600L modem to the
Terminal Mounting Strip screw terminals.
1. Cut the resistor/Yellow wire off of the pin on the White wire ( do NOT cut the pin off of the
white wire ).
2. Connect the pin on the Black & Green wire to the GND terminal of the Terminal Mounting Strip.
3. Connect the pin on the Red wire to the SW2 terminal of the Terminal Mounting Strip.
4. Connect the pin on the White wire to the EXT AGC terminal of the Terminal Mounting Strip.
12.6.3. Hughes Modems
A serial cable (Hughes drawing 1502273) should be provided with the modem. Connect the 15 pin to the
serial port on the HX-150 or HX-200 modem and the RJ-45 connector to the Terminal Mounting Strip
“Console Port”. Refer to instructions from your service provider for specific setting requirements.