Sea Recovery Aqua Mini 170, Руководство пользователя

Страница: 75 / 170

Chapter
9
Maintenance and Repair
Individual Component Maintenance and Repair
1. Inlet Thru Fitting [1]: Non Sea Recovery component. Keep the Inlet Thru Hull Fitting free and clear of debris
and marine growth. If the Inlet Thru Hull Fitting is clogged, this results in a low feed pressure condition, which
causes the system to shut off.
2. Cock Valve [2]: Non Sea Recovery component. The packings and connections of the Inlet Sea Cock Valve
must be tight and must properly seal. Clean the valve cavity of debris or replace the seal and seat or the entire
valve, as required. This section is under a vacuum condition while operating the system. Loose fittings or worn
seal will allow air to enter the Sea Recovery system causing continual shut down due to subsequent low feed
water pressure.
3. Sea Strainer [3]: Keep the mesh screen free and clear of debris. When the mesh screen is clogged, it results
in a low-pressure condition causing system shut off. This section is under a vacuum condition while operating
the system. If the Sea Strainer’s bowl is loose or if the O-ring seal is worn or not properly seated, air will enter
the system causing continual shut down due to subsequent low feed water pressure.
To clean the Sea Strainer:
• Remove the bowl by turning it counter-clockwise.
• Remove the Mesh Screen from the bowl.
• Remove the flat sealing gasket carefully from the bowl. The gaskets are fragile, so handle with care.
• Wipe the sealing gasket with a damp cloth. Lubricate it sparingly with Parker "O" ring lubricant.
• Place the seal back onto the bowl. Seat the mesh screen back into the bowl.
• Screw the lid on clockwise. Hand-tighten only enough to seal water in and air out.
4. Booster Pump[4]:
Aqua Mini 170 Booster Pump with Electric Motor: This booster pump is not economically repairable. Replace
the pump if it fails to deliver the proper flow or pressure to the system. Do not replace this pump with an
intermittent duty pump found in marine stores. Use of a different pump may cause motor over heating, damage
to the Control Box components, insufficient feed water pressure, or continual shut down of the Aqua Mini 170.
The SRC Aqua Mini 170 Booster Pump is specifically manufactured for Sea Recovery for use as a continuous
duty Feed Water Booster Pump for the Aqua Mini 170 and available only through an authorized Sea Recovery
Service Dealer or directly through Sea Recovery.
UV Light Maintenance
Follow the preventative maintenance procedures to maximize the efficiency, reliable, and longevity of the UV unit.
Refer to for recommended maintenance schedule.
Danger: The most important consideration is operator safety. The following directly relates to operator safety.
All personnel must review and comply with the following.
Caution: Operators must observe Safety Requirements at all times
73