Sea Recovery Aqua Mini 170, Руководство пользователя

Страница: 42 / 170

Press the “Booster Pump” switch, and then immediately press the “Stop” switch. Ensure that the Booster Pump
Electric Motor is turned in the proper rotation as indicated by an arrow on the front of the pump. If the motor is
turned in the wrong direction, refer to the wiring diagrams in this section to correct. To change rotation in DC
systems, reverse polarity to the respective electric motor.
Press the “Start” switch, and then immediately press the “Stop” switch. Ensure that the High Pressure Pump
Electric Motor is turned in the proper rotation. If the motor is turned in the wrong direction, refer to the wiring
diagrams in this section to correct. To change rotation in DC systems, reverse polarity to the respective electric
motor.
15. To start the system press the “Start” Switch or press the “Booster Pump” Switch and then the “Start” switch. If
the system automatically shuts off after several seconds of operation, this may be due to a system fault. Look
at the Touch Pad to confirm whether a fault has occurred. If the “High/Low Pressure” Fault Lamp is illuminated,
ensure that the System Feed Line is primed and that there is no air in the Feed Water Line. Press the Fault
Reset button on the Touch Pad and restart the system. Initial New System Commissioning will require priming
of the Feed Water through the prefiltration section in order to build sufficient feed water pressure to maintain
operation.
16. After 5 minutes of running un-pressurized, slowly adjust the Back Pressure Regulator Valve [17] by turning
clockwise to increase the pressure to the proper setting (example: Approximately 850 psi for 35,000 ppm
seawater @ 77 F).
WHILE ADJUSTING THE BACK PRESSURE REGULATOR TO OPERATING PRESSURE, OBSERVE THE
PRODUCT WATER FLOW METER.
DO NOT EXCEED 7 GALLONS PER HOUR ON THE AQUA MINI 170 SYSTEM
DO NOT EXCEED 14.5 GALLONS PER HOUR ON THE AQUA MINI 350 SYSTEM.
DO NOT EXCEED 23 GALLONS PER HOUR ON THE AQUA MINI 550 SYSTEM.
DO NOT EXCEED 31.3 GALLONS PER HOUR ON THE AQUA MINI 750 SYSTEM.
DO NOT EXCEED 900 PSI ON HIGH PRESSURE GAUGE.
17. If any abnormality develops, stop the system and correct the problem.
18. Although the system is producing “product water”, the “product water” may not be “potable” for up to 30 minutes.
The salinity of the Product Water diminishes gradually, until it reaches the factory setting at which time it is
directed to the "potable" (good water) position and into the Post Filtration components onward to the Ship’s
Storage Tank [24]. At the same time, the Water Quality LED on the Touch Pad changes from red to green.
19. Check for:
• A constant feed water flow.
• A consistent system pressure.
• Leaks in the system.
• Abnormal noises or other occurrences.
Sea Recovery Aqua Mini 170, 350, 550 and 750 40