Sea Recovery Aqua Mini 170, Руководство пользователя

Страница: 56 / 170

7. Just prior to depleting the rinse water from the 5-gallon container, stop the system.
8. Fill the 5-gallon container with product water. NOTE: FOR OPTIMUM CLEANING RESULTS, USE WATER
BETWEEN 90 F-110 F / 32 C –43 C. DO NOT EXCEED 120 F / 50 C.
9. Add 6 ounces (1/4 bottle) of either the SRC MCC-1, MCC-2, or MCC-3 Cleaning Chemical to the water in the
plastic bucket. USE ONLY ONE CHEMICAL AT A TIME.
10. Mix and thoroughly dissolve the solution in the container.
11. The ratio for the Membrane Cleaning Chemical (MCC) is one bottle per 20 gallons of product water.
12. Configure the system for a Closed Loop Configuration.
13. Press the “Start” switch to begin circulating the Cleaning Chemical solution from the container through the
system and back into the container. Do not pressurize the system; leave the Back Pressure Regulator Valve
[17] fully open.
14. After approximately 60 minutes of circulation, stop the system (Press the stop button twice to abort the Fresh
Water Flush Cycle). NOTE: If time permits, for best cleaning results, allow the cleaning solution to sit in the
system for 4 to 6 hours and then reticulate the solution for an additional 20 minutes. This will allow the solution
to soak, dislodge, and dissolve fouling.
15. Empty the 5-gallon container by reconfiguring the system for a Once Through Rinse.
16. Press the “Start” switch to discharge the solution out the Brine Discharge Thru Hull Fitting [18].
17. Just prior to depleting the Cleaning Chemical solution from the container, stop the system (Press the stop button
twice to abort the Fresh Water Flush Cycle).
18. Fill the 5-gallon container full with non-chlorinated product water.
19. Again, configure the system for a Closed Loop Configuration.
20. Press the “Start” switch to circulate the water from the container through the system and back into the container.
Continue rinsing for 20 minutes.
21. After 20 minutes, stop the system by pressing the “Stop” switch (Press the stop button twice to abort the Fresh
Water Flush Cycle).
22. Empty the 5-gallon container by again reconnecting the Brine Discharge line to the normal position as described
in Step 15.
23. Press the “Start” switch to discharge the rinse water out the Brine Discharge Thru Hull Fitting [18].
24. Just prior to depleting the rinse water from the 5-gallon container, stop the system (Press the stop button twice
to abort the Fresh Water Flush Cycle).
25. Fill the 5-gallon container with non-chlorinated product water.
26. Start the system to begin final rinsing of the system and discharging out the Brine Discharge Thru Hull Fitting
to waste.
27. Just prior to depleting the Final Rinse Water from the container, stop the system (Press the stop button twice
to abort the Fresh Water Flush Cycle).
The system is now ready for additional cleaning, storage, or use.
28. If further membrane cleaning is necessary, repeat Steps 8 through 27 for each additional cleaning.
29. If cleaning is completed and the system is to be stored:
a) Press the “stop” switch once to place the Fresh Water Flush in the stand-by mode
b) Reconnect the system’s Suction and Discharge Lines to normal operating position.
c) Leave the Inlet Seacock Valve in the closed position.
30. If cleaning is complete and the system will be operated again within a short period of time:
a) Reconnect the system’s Suction and Discharge Lines to normal operating position.
Sea Recovery Aqua Mini 170, 350, 550 and 750 54