Sea Recovery Aqua Mini 170, Руководство пользователя

Страница: 30 / 170

Installation Cautions
1. Do not over tighten PVC fittings. If threaded pipe fittings leak after installation, remove the fitting, clean the
mating threads, apply 3 to 4 wraps of Teflon tape to the male threads and thread the parts back together. PVC
fittings should only be hand tightened.
2. The Inlet Connection [1], Sea Strainer [3], Inlet 3-way Clean/Rinse Valve [30], and Booster Pump [4] should be
below water level. This will aid the Booster Pump in priming.
3. Always allow hoses and tubes to enter and exit straight from the connection for a minimum of one inch prior to
a bend
4. Avoid skin and eye contact with the membrane packaging solution. In case of skin contact, rinse the skin
thoroughly with water. In case of eye contact, flush repeatedly with water and notify a physician immediately.
Membrane Element are stored in sodium bisulfite.
5. NEVER mount any liquid holding component of the system above an electrical or electronic circuit or device.
Extensive damage to the electrical or electronic device or circuit will result if water spills from the system during
maintenance and or component failure.
Reverse Osmosis Membrane Element Susceptibility to Chemical Attack
Caution: Do Not expose the Sea Recovery System to intake Feed Water containing:
N-chlorioisocyanurates chloramines-T chloramines Hydrogen peroxide
iodine chlorine hypochlorite Chlorine dioxide
petroleum products phenolic disinfectants Bromide Bromine
Any chemical, not approved in writing by Sea Recovery.
USE OF NON-AUTHORIZED OR MISUSE OF AUTHORIZED CHEMICALS VOIDS SYSTEM WARRANTY . Do
not connect any water line to the System that may contain any of the above listed chemicals. Example: Do not
connect the inlet of the System to the ship’s potable water system if the system contains chlorinated or brominated
water. These chemicals destroy the copolymer components within the system. These oxidants and others also
damage the R.O. Membrane Element. The Sea Recovery Optional Fresh Water Flush Accessory removes chlorine
and bromine from the ship’s potable water system.
Distance Between Components
1. 20 feet (6 meters) of 1/2” (12.7 mm) ID inlet suction hose is supplied for connecting:
Inlet of to Outlet of
Sea Strainer [3] Sea Cock Valve [2]
Inlet 3-Way Clean/Rinse Valve [30] Sea Strainer [3]
Rinse/Clean bucket or container Inlet 3-way Clean/Rinse Valve [30]
Booster Pump [4] Inlet 3-way Clean/Rinse Valve [30]
Fresh Water Flush Check Valve [26] Booster Pump [4]
Plankton Filter [5] Fresh Water Flush Check Valve [26]
Prefilter [6] Plankton Filter [5]
High Pressure Pump [11] Prefilter [6]
2. 20 feet (6 meters) of 3/8” O.D. (9.5 mm) nylon tube is supplied for connecting:
Inlet of to Outlet of
Discharge 3-way Clean/Rinse Valve [31] System Brine Discharge
Rinse/Clean Bucket or container Discharge 3-way Clean/Rinse Valve [31]
Thru Hull Discharge fitting [18] Discharge 3-way Clean/Rinse Valve [31]
Sea Recovery Aqua Mini 170, 350, 550 and 750 28