11
For the installation and use of this appliance, the fitter and the user should strictly adhere to local and
national regulations as well as australian & new Zealand Standards aS/nZS 2918:2001. they should
also comply with the instructions and recommendations detailed in this manual. Safety and operation
of the fireplace is directly dependent thereon. The liability of the manufacturer can neither be retained
nor assured following failure of installation or incorrect use which does not comply with aS/nZS
2918:2001.
As each installation is a particular case, a qualified and licensed trades professional should take all
required preliminary precautions depending on the technical elements inherent to each job.
in-observance of the assembly instructions in conjunction with aS/nZS 2918:2001 entails the liability
of the person who carries it out.
as a result of faulty assembly, irrational use of parts or additional components that were not supplied
by the manufacturer, and/or modifying of the appliance or components will result in inferior or unsafe
operation. should this occur the manufacturer bears no liability, and will result in a null and void product
warranty.
PrEliMinary install inForMation
all images and diagrams in this manual are for installation reference purposes only and are not to
scale. the distributor and manufacturer bears no accuracy of these images and accepts no liability. the
purpose of these images and diagrams is to act as a guide in conjunction with the written components
and are not to instruct independently. the order of these steps are a recommendation only.
it is strongly recommended that the licensed trade professional who is performing the installation of
this appliance, completely read and understand all instructions in this manual prior to proceeding.
Sculpt Fireplaces & Axis reserves the right to change these specifications without prior notice.
PlEasE rEaD Prior to install
aCCeptable VarianCe allowanCe
Due to the production of these hand assembled and manufactured fireplaces, there is an acceptable
allowance of 3-5mm variance of the unit, including the door frame. this variance in production is non-
claimable under any warranties.
heat resistant materials
Heat resistant materials must meet aS/nZS 2918:2001 clause 1:5.21 a material with an allowable
service temperature of 600° celsius or greater.
3. preliminary inStall GUide
