SCIFIT ISO7000R, Руководство по обслуживанию

Страница: 53 / 82

53
Q. Idler Replacement
1. Remove the brake by following steps 1-12 of the removal section of the
brake replacement procedure.
2. Using a 9/16” socket, remove the nut and lock washer holding the idler to
the monocoque. This is located in the right outer side of the monocoque.
3. Remove the bolt that runs through the center of the idler.
4. Insert the bolt through the idler and back into mounting hole.
5. Install the lock washer and nut onto the idler mounting bolt. Tighten nut.
6. Reinstall the brake assembly by following steps 1-5 in the installation
section of the brake replacement procedure.
R. Crank Arm Removal / Replacement
1. Remove the crank bolt (P1081), using an 8mm Allen wrench.
2. Pull the crank arm (P1191-1 for right side or P1191-2 for the left side) off
the end of the spindle crank shaft. In some instances, this may require the
use of a crank puller.
3. To reinstall, place crank arm on the end of the spindle crank shaft. Make
sure it is phased 180° from the opposite side crank arm.
4. Place a drop of green loc-tite on the crank bolt threads and reinsert into
the end of the spindle crank shaft.
5. Tighten crank bolt, using an 8mm Allen wrench.