SCIFIT ISO7000R, Руководство по обслуживанию

Страница: 59 / 82

59
2. Remove the cover support (A1546), using a ½” wrench or socket. Four
(4) bolts are located at the top of the support and two (2) at the bottom.
Older machine only had two (2) bolts located at the top.
3. Remove the two (2) 5/16” bolts holding the right side jackshaft bearing
mount (A1661) in place, using a ½” wrench.
4. Pull the right side jack shaft bearing mount off the end of the jack shaft
(A1662).
5. Slide the poly-v belt (P1664) off the right side of the 6” poly-v pulley
(P1097).
6. Slide the poly-v belt off the brake pulley (P1576) and pull from underneath
the idler (P1091).
7. Guide the poly-v belt through the gap in the monocoque created by the
removal of the right side jack shaft bearing mount and remove from the
unit.
8. Guide the new poly-v belt through the same gap.
9. Thread the poly-v belt under the idler and reinstall on the brake pulley.
10. Install the poly-v belt on the 6” poly-v pulley.
11. Install the right side jack shaft bearing mount on the end of the jack shaft.
12. Re-install the two (2) 5/16” bolts to mount the right side jack shaft bearing
mount back to the monocoque, using a ½” wrench.
13. Verify the alignment of the poly-v belt by turning the pedals and verifying
the belt rides in the center portion of the idler. If the belt doesn’t ride in the
center portion of the idler, move the belt over on its respective pulley.