16
SM6016
NOTE: The meter will automatically switch to consume power from the AC adapter
instead of the battery when an AC adapter is plugged in and consume the power
normally. In this event, if the battery installed correctly is rechargeable, charging
controller will be driven at the same time no matter the instrument is on or off.
5.3 Low Battery Indication
At the use of battery for power supply, if the display starts flashing the
indicator,
it means that the battery voltage is below normal working voltage (below 6.8V). It is
highly recommended that the battery be replaced as soon as possible before
continuing operation. See “Installing Battery” for instructions.
If the battery is rechargeable, when the
indicator starts flashing, please charge
the battery before continuing operation. When the external source is plugged in, the
flash of RMT/
☼
indicator indicates the charging state.
5.4 Backlight Display
In the case of lacking light, turn on the back light to help read the data.
To turn on the back light, you should press the button
☼
for 2 seconds.
To turn off the back light, you should press the
☼
button for 2 seconds.
When Using Battery Power
When the meter is powered by using battery, the brightness of the back light will
automatically decrease to conserve battery power. When the back light have
lightened for about 15 seconds, the brightness will continuously decrease; and when
the back light have lightened for approximate 30 seconds, the back light will
automatically turn off.
When Using External Power
When the meter is powered using an external AC adapter, once the back light is
turned on, it will stay at its maximum brightness continuously and will not
automatically turn off. Unplugging the external power to use battery power, the back
light will decrease its brightness and automatically turn off.
5.5 Charge Display
The power circuit of SM6016 is rechargeable. When the external power adapter is
plugged in, the power mode will automatically switched and charge the internal
chargeable battery.
Single charge circle is about 160 minutes and charge current is approximate 120mA.
If a battery is full charged, the charge will be automatically shut off; instead, the
battery will be charged again after a charge circle.
NOTE:
A new charge circle will begin as soon as an
external power is connected.
WARNING: If the instrument has rechargeable circuit, DO NOT connect to an
external power when a non-rechargeable battery is installed. Doing so will
cause the burst of the battery.
：
It indicates low power of a battery before the connection of external power; after
the connection, it means the charging state. RMT/
☼
indicator will be light up in the
condition of being charged no matter the instrument is off or on.
Содержание SM6016
Страница 1: ...Hand Held LCR Meter SM6016 User Manual ...
