10
11
schwankgroup.com/monsterfans
schwankgroup.com/monsterfans
1. Level the mounting brackets and mark the centre of the top two mounting holes.
Drill the remaining top two mounting holes.
2. Before tightening the structural nuts and bolts, ensure the bracket is plumb and level then
proceed with tightening the mounting brackets to the glu-lam.
3. Fasten studded mount assembly to four ¼” x 1-1/4” long hex cap screws already in place using
four ¼” flat washers and four ¼ nylocks.
4. Continue onto page 20 to complete the fan installation.
1. From an accessible landmark, on the first purlin, measure to the centre line of the bottom
centered hole of the 3 mounting holes.
2. Drill the centered bottom mounting hole with a ½” drill bit, so that there will be a minimum of ¾”
[19mm] between the top of the mounting bracket deck and the bottom of the purlin.
3. Place the two mounting bracket faces together with each bracket bottom deck face outward.
4. Before fastening the mounting brackets install four ¼” x 1 1/4” long hex cap screws with ¼” flat
washers into slots in mounting bracket deck facing down.
5. Using a 3/8” X 1-1/2” hex cap screw and 3/8” nylock nut, suspend the mounting brackets using
the center bottom hole only.
6. Level the mounting brackets and mark the centre of the top two mounting holes.
Drill the remaining top two mounting holes.
7. Before tightening the structural nuts and bolts, ensure the bracket is plumb and level then
proceed with tightening the mounting brackets to the purlin.
8. Fasten studded mount assembly to four ¼” x 1-1/4” long hex cap screws already in place using
four ¼” flat washers and four ¼ nylocks.
9. Continue onto page 20 to complete the fan installation.
Purlin Mount
Installation Procedure
Installation Procedure
