8
9
schwankgroup.com/monsterfans
schwankgroup.com/monsterfans
Glu-Lam Mount
Installation Procedure
Installation of the Mounting Hardware
Note:
Consult a structural engineer before installation. Choose one of the following mounting options
for your Fan and follow the corresponding steps. The mounting kits included in the Fan package are
glu-lam, purlin, OWSJ and web truss.
Tools Required
•
Level
•
Ratchet or impact gun
•
3/8”, 7/16” and 9/16” Imperial socket to fit bolt heads and nuts
•
7/16” and 9/16” Imperial wrench to fit bolt heads and nuts
•
#2 Phillip screwdriver
•
Lifting device or scaffolding
•
Appropriate personal protective equipment
•
Drill [optional]
•
Drill bit set up to ½” diameter [optional]
Items Included
•
Motor Assembly
•
[5] Blades [Optional Color]
•
[1] LF/SP Assembly
•
[1] Packaged Assembly Hardware
•
[1] Packaged HMI Control
•
[1] Packaged Wire Harness
•
[1] LED Light Kit [Or Lens]
•
[1] Hub Cover [Optional Color]
Hardware Included
•
Mounting Plate
•
[2] Mounting Brackets
•
[3] 3/8 x 9” B7 Threaded Rod W/ Nut
•
[2] Hex Cap Screw 3/8” X 3”
•
[5] 3/8 Nylocks
•
[10] 3/8 Flat Washers
•
[20] ¼ x 5/8 Serrated Flange Head Cap Screw
•
[5] #8-32 x 1 3/8 Machine Screw
•
[1] 1/8” Cable Clamp
•
[1] Studded Mount Assembly
•
[8] ¼ Flat Washers
•
[8] ¼ Nylocks
•
[4] ¼ x 1 ¼ Hex Cap Screw
•
[3] 3/8 x 1 ½ Hex Cap Screw
•
[1] Stand Off Ring
Note:
Illustrations may be changed without notice. All dimensions and specifications are approximate
and drawings are not to scale. Specifications are subject to change without notice.
Warning!
Use of any other mounting hardware or
technique is strictly prohibited.
Only use mounting hardware/ brackets supplied
by MonsterFans Style Series.
1. From an accessible landmark, on the glu-lam, measure to the centre line of the bottom centered
hole of the 3 mounting holes.
2. Drill the centered bottom mounting hole with a ½” drill bit, so that there will be a minimum of ¾”
[19mm] between the top of the mounting bracket deck and the bottom of the glu-lam.
3. Place the two mounting bracket faces one on each side of the glu-lam with each mounting
bracket bottom deck face inward.
4. Before fastening the mounting brackets install four ¼” x 1-1/4” long hex cap screws with ¼” flat
washers into mounting bracket deck facing down.
5. Using a 3/8” X 9” threaded rod with welded nut and 3/8” nylock nut, suspend the mounting
brackets using the center bottom hole only.
Installation Preparation
