14
15
schwankgroup.com/monsterfans
schwankgroup.com/monsterfans
5. Ensure wires are not compromised and tighten ¼” nylock nuts to secure the motor assembly to
the studded mounting assembly.
6. Anchor the safety cable, allowing ¾” [19mm] of slack cable, and secure to solid point of the glu-
lam, purlin, OWSJ, wood truss or building structure using supplied cable clamps.
7. The power cable must be secured to a solid point of the glu-lam, purlin, OWSJ, wood truss or
building structure. The power cable is to be fastened so there is absolutely no slack in line, in order
to allow the safety disconnect to function as designed. [see “Electrical Installation” section of
manual.
8. Install all five blades [see “Blade Installation” section of manual].
9. Install Light Kit [see “Light Kit Installation” section of manual].
10. Install Hub Cover [see “Hub Cover Installation” section of manual].
1. Using 3/8” socket fasten blade to hub plate on the bottom of the motor assembly.
2. Insert four ¼” x 5/8” serrated flange hex cap screws through all four holes in blade.
3. Thread hex cap screw into hub plate until blade is fastened tightly.
4. Repeat first 3 steps for each of the remaining blades.
5. Turn fan by hand to ensure that there are no obstructions with the blades.
Installation Procedure
Installing the Optional LED Light Kit
Installing the Blades
Caution!
to reduce the risk of fire, electric shock,
or injury to persons, disconnect the electrical
supply circuit to the fan before installing light kit.
The light kit is pre-assembled for visual understanding of assembly, and will need to be disassembled
to install.
1. Remove light kit from box
2. Using a Phillips screwdriver, remove the four - #6 x 3/8 screws and the two electrical box clips
to free the LED panel light from the electrical box. Inside, there will be three #8 x 3/8 pan head
machine screws.
3. Direct the LED power wire on the bottom of the motor assembly through the electrical box.
Mount the electrical box to the bottom of the motor assembly using the three #8 x 3/8 pan head
machine screws ensuring wiring is not compromised.
4. Plug the LED panel light into the power wire.
5. Install the four - #6 x 3/8 screws and the two electrical box clips to secure the LED panel light to
the electrical box in the same manner it was packaged.
