22
34
39
29
n
22
22
6 Maintenance
EN BEF 400RC floor milling machine with remote control
BEF400RC‐en‐221018
24
5.7 Stopping operation
Before leaving the machine, the relevant operator must
stop operation.
Risk of injury from high voltage.
There is still residual voltage even after the machine has
been switched off.
To disconnect the machine from the power supply,
disconnect the CEE connector [22] from the mains.
1.
Move the
Milling joystick [29] in the direction.
The machine stops.
Both support wheels [5] are moved down to the stop. The
milling rotor stops and is lifted off the floor.
Risk of injury from milling rotor still rotating after the ma
chine is switched off.
The milling rotor may continue to turn for several seconds
after switching it off (follow‐up movement).
The operation is stopped.
2.
Report any faults and notes to the relevant supervisor.
6 Maintenance
Observe the safety instructions in Chapter 2.2.
Risk of injury
from high voltage.
All repairs to the electrical system may only be carried out
by skilled electricians.
Prior to doing any work on the electrical system and prior
to starting, maintenance, cleaning, repairs or similar work,
do the following:
—
Disconnect the power plug [22] .
GG"
The machine must be serviced according to the in
structions in this operating manual. Otherwise the warranty
will become void.
Inspections and maintenance must be conducted in ac
cordance with the schedule in the operating manual.
Cleaning, maintenance and repair work may only be carried
out by trained specialist personnel (! Chapter 12, page 32).
The maintenance personnel responsible for the machine
must ensure that no‐one can enter its danger zone during
maintenance work.
Only genuine spare parts supplied by the manufacturer
may be used.
Operation must be stopped before starting maintenance
work (
!
Chapter 5.7, page 24)!
