n
34
39
n
49
A
B
C
D
E
5
n
5 Operation
EN BEF 400RC floor milling machine with remote control
BEF400RC‐en‐221018
21
7.
If the machine does not run smoothly and/or the milling
pattern is wavy and uneven:
a.
First reduce the travel speed (
!
Chapter 5.5, page 18).
b.
If necessary, stop and reduce the milling depth:
Turn both cranks anticlockwise ↻ until the required
milling depth is set.
8.
Press the two
Support pushbuttons (34/39) in the direction.
The rotating milling rotor is slowly lowered to the set milling
depth in the floor.
9.
Floor milling.
When the right support is swivelled forwards, only correc
tions to the direction of travel should be made and no tight
corners should be moved along.
5.6.1 Swivelling the support
The operating personnel responsible for the machine must
ensure that no‐one can enter the machine's danger zone
during operation.
For swivelling, it must be possible to move the support wheel
freely above the ground.
1.
Place the machine on a flat, horizontal and firm surface.
2.
either
Raise the supports and lower the milling rotor:
— Press the two
Support pushbuttons (34/39) in the
direction.
Both support wheels [5] are moved up and the milling
rotor is lowered on to the floor.
or
Raise the machine using a lifting device (e.g. crane):
— Raise the machine at the rear right using a sling [49] until the right support can be swivelled.
3.
Unlock the locking pin and pull it out of the pin (A).
4.
Pull out the pin (B).
5.
Swivel the support unit forwards (C).
6.
Insert the pin up to the stop (D)
7.
Insert the locking pin in the pin and lock it (E).
The support unit is in the front position.
