n
32
34 35
37 38 39
29
n
n
n
n
5 Operation
EN BEF 400RC floor milling machine with remote control
BEF400RC‐en‐221018
16
The machine can drive short distances without a high‐voltage
power supply in battery mode. The high‐voltage power supply is
required for the milling drum drive and for charging the batteries.
Danger due to automatically moving machine.
The operating and maintenance personnel responsible for
the machine must ensure that no one can enter the ma
chine's danger zone during operation or maintenance work.
If the milling rotor is in operation, the running machine can
only be stopped using the
Milling joystick [29] or an
EMERGENCY STOP button [27/37] .
The machine has been put into operation
(
!
Chapter 5.2, page 13).
1.
Press the two
Support pushbuttons [34/39] in the direc
tion.
Both support wheels [5] are moved down to the stop and
the milling rotor is lifted off the floor.
For manoeuvring and driving short distances, the milling
drive that is raised off the floor can remain switched on.
2.
Use the
Driving joystick [32] to control the direction of tra
vel.
The display is as illustrated.
If the
Milling joystick [29] is moved in the direction or an
EMERGENCY STOP button is pressed, the machine
stops.
In automatic mode, both support wheels [5] are moved
down to the stop. The milling rotor stops and is lifted off the
floor.
The travel speed is permanently set to the maximum.
The travel speed in m/min is shown on the display.
GG"
The manufacturer recommends performing a test drive.
3.
If necessary, correct the straight‐ahead direction with the
direction adjustment [38].
A correction is shown on
the display.
