Schwamborn BEF 400RC, Руководство пользователя

Страница: 19 / 36

34 39
n
45
n
5 Operation
EN BEF 400RC floor milling machine with remote control
BEF400RC‐en‐221018
19
Deviations can be corrected by different settings of the
cranks [11].
7. Use both cranks to turn the stops [12] down clockwise ↻
up to the stop (
!
Figure C).
The set milling depth is now 0 mm.
8. Loosen the 2 knurled nuts [46] and move the milling depth
scale [47] until the pointer [48] indicates 0 (zero) and tigh­
ten the knurled nuts.
9. Turn both cranks anticlockwise ↺ until the required milling
depth is set (
!
Figure D).
One turn of the crank corresponds to a lowering distance of
2 mm. Example:
Example: If a milling depth of 8 mm is required, both
cranks must be turned 4 turns anticlockwise ↺.
GG"
The maximum milling depth: 10 mm (green scale range)
Die maximum work depth for separating: 30 mm.
Do not fail to observe the inclination indicator [45].
Risk of damage due to excessive milling depth.
Milling with a greater milling depth than specified here
will result in significantly increased wear on the milling
rotor and the machine.
This must be avoided.
10. Tighten both clamping wheels [13].
If the cranks [11] were turned up to the stop anticlockwise
↺, the milling depth can also be set using the
Support pu­
shbutton [34/39] (inaccurate method).
The milling depth and the milling angle have been set.
5.6 Floor milling
Risk of injury from rotating milling rotor.
Do not reach or step near the milling rotor.
Never allow unauthorised persons to approach the machine.
Risk of injury from automatic movements.
The operating personnel responsible for the machine must
ensure that no‐one can enter the machine's danger zone
during operation.
Risk of injury from loud noises.
Use hearing protection.
Risk of injury
from accumulation of dust during milling work.
The machine may only be operated with water spraying
and/or a dust extraction system with appropriate filtration.
Use respiratory protection.
Risk of injury.
All persons in the working area of the machine must wear
appropriate tight‐fitting work clothing and safety footwear.