n
n
n
n
n
n
n
5 Operation
EN BEF 400RC floor milling machine with remote control
BEF400RC‐en‐221018
13
5 Operation
Observe the safety instructions in Chapter 2.2.
Only persons who have been instructed accordingly may
work on and with the machine. (
!
Chapter 12, page 32).
5.1 Preparing for operation
1.
Clean the machine if necessary (
!
Chapter 6.4, page 26).
2.
Remove tools and materials not required for operation from
the machine.
5.2 Starting up the machine
The machine may only be put into operation by qualified
specialist personnel.
A visual inspection of the machine needs to be carried out
before starting up the machine.
In doing so, pay particular attention to wear, damage and
loose components.
GG"
The manufacturer strongly recommends practising the use
of the remote control of the machine and milling or cutting
sufficiently before working.
The operating personnel have been instructed in all action
and knowledge required for operation on the basis of the
operating manual (
!
Chapter 12, page 32). The operating
personnel have practised the use of all operating elements
and can operate the machine accurately and safely.
1.
Check that the machine is in a correct condition:
There are no objects on the machine.
All hydraulic hoses and hydraulic connections are un
damaged and tight.
The suction hose does not have any cracks or holes.
The hose clamps have been tightened.
The milling rotor is correctly mounted and in usable
condition.
The inclinometer is tight and working properly.
All covers have been fitted correctly.
The operating personnel responsible for the machine must
ensure that no‐one can enter the machine's danger zone
during operation.
