Maintenance
7.3 Changing swiveling stop
Disassembling
1. Read the position of the swiveling stop (2) off the scale and
mark it if necessary.
2. Remove the screws (3).
3. Remove the swiveling stop (2) carefully.
Note: leave the circular T-nut (1) in the slot.
4. Remove the swiveling stop (4) in the same way.
Assembling
1. Fasten the swiveling stop (2) to the circular T-nut using
screws (3). Tighten the screws (3) only slightly.
2. Push the swiveling stop (2) in the slot to the marked position.
3. Tighten the screws (3).
✓
Observe the tightening torque, see following table.
4. Install the swiveling stop (4) in the same way.
5. Check the angle of rotation and readjust it if necessary.
Tightening torque [Nm]
Item Designation
EGS
25
40
3
Screw [Nm]
0.68
1.2
47
05.00 | EGS | Assembly and Operating Manual | en | 389746
