Assembly and settings
Adjusting the sensor.
The sensor brackets (8) are fixed using the screw (6) in the circular
groove.
1. Align product to the first swivel position.
2. Loosen screw (6) until the sensor bracket (8) can be slid into
the groove.
3. Align sensor bracket (8) so that one switching lug (4) is above
each sensor.
4. Tighten screw (6) in order to fix the sensor bracket (8).
Tightening torque: 0.3 Nm
5. Proceed identically with the second sensor bracket in the
second swivel position.
Adjusting the slider
1. Undo the screw (2).
2. In order to set the sensor for "Workpiece gripper", for
instance, grip the workpiece manually with the application-
specific fingers and push the slide (7) axially to the switching
lug (4) until the sensor switches.
3. Tighten screw (2) in order to fix the sensor in the sensor
bracket (8).
Tightening torque: 0.08 Nm at EGS 25, 0.1 Nm at EGS 40
4. Proceed identically for the second gripper position and the
second swivel position with the other sensors.
39
05.00 | EGS | Assembly and Operating Manual | en | 389746
