GB
21
S
w
it
c
h
in
g
t
h
e a
pp
lian
c
e o
ff
Disconnect your appliance from the electricity
supply before carrying out any work on it.
C
l
e
anin
g
t
h
e
a
pp
lian
c
e
The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in
lukewarm water and neutral soap. If these stains
are difficult to remove, use only specialised
products. After cleaning, rinse and dry
thoroughly. Do not use abrasive powders or
corrosive substances.
Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft
cloth. Do not use abrasive products.
All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
Never use steam cleaners or pressure cleaners on
the appliance.
C
l
e
anin
g
t
h
e
o
v
e
n
d
oo
r
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
To clean more thoroughly, you can remove the oven
door.
1. Open the oven door fully (
see diagram
)
2. Lift up and turn the small levers located on the
two hinges (
see diagram
)
3. Grip the door on the two
external sides and close it
approximately half way. Pull
the door towards you lifting it
out of its seat (
see diagram
).
To replace the door, reverse
this sequence.
I
ns
p
ectin
g
t
h
e
seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre (
see Assistance
).
W
e
recommend not using the oven until the seals have
been replaced.
R
e
p
la
c
in
g
t
h
e
li
gh
t
b
u
l
b
To replace the
oven light bulb*:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar
one:
W
attage 25
W
, cap E 14.
3. Replace the glass cover (
see diagram
).
A
ss
i
s
tan
c
e
W
a
r
nin
g
:
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions.
Malfunctions are displayed by messages of the
following type: ER followed by numbers.
Call for technical assistance should a malfunction
occur.
B
e
f
ore
callin
g
f
or
A
ssistance
:
Check whether you can fix the problem yourself.
Restart the programme to check whether the
malfunction has disappeared.
If it has not, contact the Authorised Technical
Assistance Service.
Never use the services of an unauthorised
technician.
P
lease
h
a
v
e
t
h
e
f
ollo
w
in
g
in
f
or
m
ation
to
h
an
d
:
The message displayed on the TEMPERATURE
display.
The appliance model (Mod.).
The serial number (S
/
N).
The latter two pieces of information can be found on
the data plate located on the appliance.
M
aintenance
an
d
care
