Schmalz SXMPi, Руководство по эксплуатации

Страница: 21 / 66

Operating and Menu Concepts
EN-US · 30.30.01.01721 · 01 · 09/19 21 / 66
5 Operating and Menu Concepts
The ejector operated using four buttons on the foil keypad.
MENU BUTTON UP BUTTON
ENTER BUTTON DOWN BUTTON
Settings are configured in software menus. The following menus are available:
• Main menu: for standard applications
• Configuration menu: for applications with special requirements
• System menu: for reading out system data such as counters, the software version, etc.
If settings are changed, undefined states of the system may occur for a short time (for approx. 50 ms).
The following information can be shown on the display:
• The current vacuum measurement value
• The selected menu item
• The settings
• Error messages in the form of error codes
In the basic operating menu state, the actual measurement value of the vacuum is displayed on the basis
of the chosen display unit. All units are available in millibar, kilo pascal, inch-hg and PSi. The measured
value is displayed as a positive compared to the ambient air pressure.
After a parameter is set in the operating menu, the power supply of the switch must remain
stable for at least 3 seconds. Otherwise, there may be a loss of data and the resulting error
E01
.
The menus will automatically close if no buttons are pressed for 1 minute.
The display also returns to the basic status when an error status occurs so that the error code can be dis-
played. A menu can be called up and used again afterward.
5.1 Button Assignments in Display Mode
In display mode, a specific function is assigned to each key.
5.1.1 Opening the Menu
Press the MENU BUTTON to open the menus as follows:
4
Press the button briefly.
ð The current production setup profile is briefly displayed, and the main menu opens with the first pa-
rameter [
X-1
].
4
Press the for about three seconds.
ð The display flashes [-C-]
ð The configuration menu opens with the first parameter [
ctr
].