Scaime IPB 50, Инструкция по эксплуатации

Страница: 9 / 28

IPB50
8
Analog output (option)
AOUt AO g
Functioning with analog output on the gross weight
AO n1 Functioning with analog output on the net weight (see below)
AO n2 Functioning with analog output on the net weight "
AO n1 Functioning with analog output on the net weight "
AO n1
Functioning with analog output on the net weight "
Nota : If the setpoints are on the gross (StPG), the analog output on the net value is impossible.
AOMA Unscrew the OFFSET trimmer completely (50 turns).
once pressed
↵
the message AOMA starts to blink. Adjust the output in voltage at the desired
value when the scale is at f.s. capacity through only the GAIN trimmer (rough adjustment) and
the OFFSET trimmer (fine adjustment). Once the operation is finished, press any key.
AOZE
once pressed
↵
the message AOZE starts to blink. With this step it is possible to adjust the
output value of the analog interface when the scale displays a zero weight. The function of the
keys are the following:
•
->0<-: forces the analog output at the minimum value;
•
->T<-: increases the output value of the analog interface in small increments
•
Fn : increases the output value of the analog interface in a large increments
• ↵
: fine adjustment and advancement to the next step.
AOMI once pressed
↵
the AOMI message will start blinking. With this step it is possible to adjust the
minimum output value of the analog interface. The keys have the same functions described in
the previous step.
PrMO
Pron If the indicator has been furnished with an optional printer, it is always on.
PrES The printer turns on only when a report has to be executed.
To use only when the printer is equipped with a “BATTERY SWITCH”.
Prno
Printer off.
NOTE: If uses the RS485 output, it is necessary to set Prno
.
Depending of the printer used