sauter EQJW145, Руководство по эксплуатации

Страница: 76 / 110

EQJW145: Heating controller
Communication functions
76
7010015003 A
© Fr. Sauter AG
6.4.3 Sending SMS if there is a fault on the installation
A modem enables the controller to send an error message to a mobile
phone. As soon as a fault is registered in the device status register of the
controller, an SMS message is sent. This requires modem access from a
provider (SMSC = Short Message Service Center) which accepts SMS
messages in TAP protocol. The message on the display of the mobile phone
will then read something like this:
'Heating controller EQJW 145/device status: [XXXX]/Note: 0 = no error. >0 =
error has occurred'
The value shown for the device status corresponds to the value of SERVice
parameter SP02. The error that has occurred is stored in this value in
encoded form (see Section 7.1.2). The SMS Center usually sends the date,
time and sender's telephone number for this message.
Access numbers
6
for SMSC:
D1 network of Deutsche Telekom: 0171 2521002
ditto via ISDN using X.75: 0171 2521001
O2 Germany: 0179 7673425
E-PLUS Germany: 0177 1167
Cellnet (GB) 0044 7860980480
To enable the function, CP02 must be set to 4 (or 5) and the telephone
numbers of the provider (SMSC) and the mobile phone must be entered at
CP07 and CP08 (see Section 3.2).
6.4.4 Displays for modem operation
When modem operation is enabled, an additional item appears in the display
loop to show the current modem status. The following displays may appear
here:
Display Meaning
FrEE
No communication, modem on standby
PAUSE
No communication, dialling pause has not yet
elapsed (however, calls are accepted)
init
Modem is being initialised
Conn
There is a connection to the provider or the
control station
CALL
The connection is being built up
6
No guarantee is given of the availability and correctness of these numbers. Up-to-
date information on this subject must be requested from the network operator.