Saphire Scientific 370 SS, Руководство по эксплуатации и обслуживанию

Страница: 27 / 81

SECTION 3
22
SAPPHIRE SCIENTIFIC MODEL 370 SS ®
PART# 49-038 REV F
SHUT DOWN AND DAILY
MAINTENANCE
1. Flush out the chemical system with fresh
water to remove any chemical residue.
2. Remove as much moisture from the vacuum
hoses as possible. This will prevent spillage of
wastewater in your vehicle when returning
hoses.
3. Turn the water supply faucet off. Loosen the
water supply hose at the water supply to bleed
off any pressure. Unhook the water supply hose
and return it to the vehicle.
4. Disconnect the vacuum hose from the front of
the unit.
5. Adjust the throttle cable to the idle position.
6. Turn the temperature control switch to the
OFF position.
7. Allow the unit to run for at least
5 minutes
with the bypass valve open. This will also help
to remove any excess moisture from the vacuum
pump and cool the unit down.
NOTE: If shutting down for the day: Plug the
vacuum inlet on the front of the unit and set the
throttle control cable to high. Spray WD-40 (or
equivalent) into the blower lubrication cup,
located on the right hand side of the control
panel for 5 seconds . Let machine run 2 minutes
to disperse lube to blower. Unplug the vacuum
inlet and remove load. Next, return the throttle
control cable to idle position
,
and let idle for 3
to 5 minutes.
8. Turn the ignition switch to the OFF position.
9. Activate the valves on all cleaning tools. This
will relieve any remaining pressure. Disconnect
the cleaning tools and solution hoses and return
them to the vehicle.
10. Drain the waste tank, disposing of
wastewater in a suitable and proper location.
!
NEVER
dispose of wastewater in a storm drain,
water way or on ground areas. Always dispose
of waste in accordance with Local, State, and
Federal laws.
11. Remove the strainer basket from the waste
tank. Clean out any debris and re-install.
Microban QGC cleaner is the best product for
cleaning and sanitizing the waste tanks as well
as other parts of the system
NOTE: Damage may occur to the vacuum
pump. Replacement and maintenance of the
filter will prevent rust and corrosion from
entering the vacuum pump.
12. Inspect the vacuum inlet filter inside the
waste tank
daily
. Remove and clean the filter if
there is any lint or debris present.
NOTE:
To remove the vacuum inlet filter, grip
the plastic hexagon section of the filter.
Gripping the filter by the screen will collapse or
destroy the filter. After cleaning, grease the
threads on the filter and replace the filter.
Tighten the filter until hand tight and then
loosen ¼ turn. This will make the filter easier to
remove when cleaning or replacement is
required.
NEVER
operate this unit with the filter
removed, damaged or improperly installed.
13. At the end of the work day, rinse out the
waste tank with fresh water. Microban QGC
cleaner as the best product for cleaning and
sanitizing the waste tanks as well as other parts
of the system
14. Clean the vehicle interior, unit, tools, hoses
etc., as needed. Inspect
ALL
equipment and
accessories for any damage, leaks, wear, etc.