3
Adjust the lens orientation. Then adjust angle of view using the zoom ring, and the focus
using the buttons.
PEAK HOLD: Shows the value of the maximum focus level.
INDICATOR: Shows the value of the current focus level.
Adjusting focus
1
Use the NEAR/FAR button to roughly focus on the subject.
Adjust by monitoring the video image on the monitor.
2
Press the SET button.
The camera automatically focuses on the subject. Note that the color of the status indicator (
A
)
“FOCUSING” turns from black to orange.
If the camera fails to automatically focus on the object, the status indicator (
A
) will indicate “ERROR”. In this
case, manually adjust the focus (in Step
3
).
3
Press the NEAR/FAR button to adjust the focus.
Adjust to set the FA bar (
B
) to the maximum level.
When the subject comes into focus, the color of the status indicator (
A
) “FOCUSING” turns from black to
orange.
Pressing the button causes the FB bar (
C
) gauge to move.
The position changes step by step each time the button is pressed and continuously at a high speed
when the button is held down.
4
Press the SET button for 2 seconds or more.
The focus adjustment screen will close.
The focus adjustment screen will also close automatically if left idle for 5 minutes or more.
If video is out of focus in either color or black-and-white mode, adjust the focus in respective modes.
Introduction 13/15
