Sanyo SPW-C0705DZH8, Технические данные инструкция

Страница: 68 / 703

3-16
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
RCS-TRP80BG.WL
2-9. Accessories
2-10. Installing the Receiver Unit
No. Accessories Quantity Accessories Quantity
1 Receiver 1
2 Remote controller 1
3 Remote control holder 1
No.
4 AAA alkaline batteries 2
5 Users Manual 1
6 Truss self-tapping screws
4 X 16 2
7 Cable tie 1
Vinyl tape
Flat head screwdriver
(Wrapped with vinyl tape)
Lid Insert into groove
on side below
" O " mark.
Clamp
Receiver
Clamp
Terminal board
Panel
Side panel
Air inlet grille
Fig. 3-7
Fig. 3-6
Fig. 3-9 Fig. 3-8
(1) Open the air inlet grille on the side panel, remove the 1 screw and then move it toward the front (direction of the arrow) and
remove it. (Fig. 3-6)
(2) Wrap the tip of a flat head screwdriver with vinyl tape and then slip it into the side of and under where " O " marking is
printed on the lid, wiggling the lid free. (Fig. 3-7) (Be careful not to scratch the panel.)
(3) After passing the lead wire through the panel, install the receiver in the hole of the panel. (The projecting parts of the
receiver is held in the hole of the panel.)
(4) Fasten the receiver’s lead wire to the clamp that is holding the wire from the louver motor. (Fig. 3-8)
(5) Attach the side panel.
(6) Put the receiver’s lead wire together with other wires such as the louver motor wire and fasten them to the clamp. (Fig. 3-9)
Use the hole in the upper part of the wiring box to lead it in.
Ceiling Suspended Model
TD831143-00̲W-3WAY.indb 16 TD831143-00̲W-3WAY.indb 16 2008/12/01 10:26:24 2008/12/01 10:26:24