Sanyo LC-XB200, Руководство пользователя

Страница: 62 / 150

Chapter 6 Basic setting and operation
✐
Replace it with a new lamp immediately and reset the lamp counter. If the projector is used without
resetting the lamp counter, the alert mail is sent to users in every power-on of the projector. This
alert mail will not be sent when the mail sending condition "When the life span of lamp is reached" is
unchecked.
●
When PJ lamp replacement time is reached:
TITLE: Message from projector
10-03-2007 00:59
Projector Model Name: model name
TCP/IP: 192.168.1.201 Projector Name: Proj05
It sends you following message.
*The PJ lamp replace time is reached.
Examples: Type and contents of alert mail
When the projector has an abnormality, the following alert messages are sent to the registered E-mail
address depending on your selected condition. Administrator or user can take an efficient action
quickly by receiving this message. This is very useful to maintain and service the projector.
The following are examples of received messages.
5
Option selection for sending alert mail
Click Option sub menu tab. Check the condition items under
which alert mail will be sent and click Set button.
Please refer to the item "Examples :Type and contents of alert
mail" described as below.
Option
[1]––––––––––––––––––––––––––––––––––
o
When PJ lamp is off.
o
When PJ lamp replacement time is reached.
o
When PJ needs service.
o
When internal PJ temperature is too high.
o
When PJ is turned into Standby in proper user
operation.
[2]––––––––––––––––––––––––––––––––––
o
When accumulated filter use time reaches
[ ] hours.
o
When Power management function turns PJ
lamp off.
o
When the signal is interrupted.
o
When Auto Play is failed.
[3]––––––––––––––––––––––––––––––––––
o
When lamp Corres. Value reaches
[ ] hours.
Attached message
✐
"When PJ lamp is off" signifies the lamp goes out
without user operation. "When PJ is turned into
Standby in proper user operation" signifies that the
projector is turned on by using the web browser
and then it is turned into standby with ON/STANDBY
button on the top control or the remote control.
✐
If condition "When Auto Play is failed" is checked, the
trap is sent when the error occurs during the auto
display operation using with the network viewer
function (
+
p.113). For further information of the
error, refer to item "Auto Display setting and control
page [3]"(
+
p.128).
✐
The length of message should be less than 255
characters.
✐
Up to 99,999 hours can be set for use time.
✐
The optional settings return to the factory default
when you unplug the AC power cord of the projector.