E-6
Cover
Tab
Tank
Cap
Tank
Cap
Tank
Cover
Replenishing the Water
Water
1
3
2
4
5
6
Do not place flammable material in the tank. This may cause a fire.
Warning
Note:
¡
Only use tap water below 86
°
F.
¡
Mold and bacteria may develop if unspecified water is used and may hinder proper operation.
¡
Dispose the water in the electrolyzed water unit and tank after removing the power plug. Without
electricity, the effect of the electrolyzed water is reduced and mold and bacteria may develop.
¡
Dispose of the water in the tank if the water has a chance of freezing. If the water freezes, it
may cause the device to malfunction.
¡
If the temperature of the water is low (10
°
C or below), the sterile electrolytic mist may not be
emitted.
¡
When filling the tank with water, let the water run freely for about 3 to 5 seconds before filling
the tank, otherwise the quality of the water remaining in the faucet will deteriorate.
Note:
¡
Wash the cap well as mold may form on the
tank cap.
Use water specified in the attached (Notes).
This may hinder proper operation.
Replace the cover.
¡
Press the cover into
place matching the
configuration.
Tighten the cap of the tank.
¡
Confirm that the cap is on securely.
Loosen the cap to the tank and fill
the tank with tap water.
¡
Fill the tank with tap water without overfilling.
As a guide, a full tank of water will last for a
maximum of about 2 to 3 weeks of operation.
(For automatic operation) The length of time
before the tank needs to be refilled will vary
depending on the usage conditions.
Replace the tank.
¡
Line up the tank.
Remove the tank.
¡
Lift the tank straight up.
Lift the tab on the cover and remove.
Note:
¡
Water attached to the cap may drip when
removing the tank. Use a towel to ensure that
the floor does not get wet.
English
ABC-VW24A_GB_US.qxd 09.10.1 4:52 PM ページ6
