SANY SY60C, Руководство по эксплуатации и обслуживанию

Страница: 98 / 160

4-34
MACHINE OPERATION
SY60C Excavator OMM
0002938
Figure 4-7
Use a loading platform or ramps when loading or
unloading the machine.
When loading the excavator with work equipment
installed, place the work equipment in the front and travel
forward.
0002942
Figure 4-8
Use the following procedures during loading:
1. Align the centerline of the machine to the trailer
centerline.
2. Slowly drive the machine up the ramps.
3. When the machine tilts toward the trailer, lower the
bucket close to the trailer floor. Drive slowly until the
tracks are completely on the trailer.
4. Slightly raise the bucket. Retract the arm and keep it
in a lower position. Slowly swing the upper structure
180°. Lower the dozer blade.
5. Fully curl the bucket and arm. Slowly lower the
boom.
0002944
Figure 4-9
NOTE: To prevent damage to the bucket cylinder, place a
wood block (1) between the bucket cylinder and
the trailer floor. Slowly lower the bucket cylinder
onto the wood block.
0002940
Figure 4-10
6. When loading the excavator without equipment
installed, travel in reverse up the ramps. Maintain the
ramps at no more than a 15° angle (1).
7. Stop the engine and turn key to ON.
8. Operate the joysticks until the pressure inside the
hydraulic cylinders is fully released.
9. Move the hydraulic lockout control lever to the locked
(closed) position.
10. Turn the key to OFF and remove from the key switch.
11. Close the cab window and door.
NOTICE!
• Never turn the battery disconnect switch to OFF
while the engine is running. This can damage the
electrical system or cause the machine to
operate improperly.
• After machine shutdown, wait at least 1 minute
for the Engine Control Module (ECM) to complete
its shutdown before turning the battery
disconnect switch to OFF.
1
1