SANY SY60C, Руководство по эксплуатации и обслуживанию

Страница: 23 / 160

SAFETY
2-3 SY60C Excavator OMM
Mount and Dismount the Machine
0003051
Figure 2-1
Mounting or dismounting the machine presents hazards.
Observe the following:
• Always make sure the machine is at a complete stop
before entering or exiting the machine. Never jump
on or off the machine.
• Never exit or enter the machine by any means other
than the provided grab handles and steps.
• Always face the machine as you mount and
dismount.
• Always maintain three-point contact (both feet and
one hand, or one foot and both hands) with the grab
handles, steps, and deck for proper support.
• Wear shoes with slip-resistant sole material.
• Do not walk on any surface of the machine if its
slip-resistant material is missing or excessively
worn. Do not step on surfaces of the machine that
are not approved for walking or working. Keep all
walking and working surfaces of the machine clean,
dry, and slip-resistant.
• Always keep grab handles, steps, and walkway
areas clean and clear of mud, oil, grease, or similar
debris. If these areas are damaged, have them
repaired or replaced immediately.
Machine Safety
Authorized Use of This Machine
This multipurpose construction machine is used primarily
for digging or loading earth and stones. It can also be
used for grading, slope-trimming, lifting, breaking,
demolishing, and trenching. SANY assumes no
responsibility for any consequence caused by use
outside this specified range.
Unauthorized Use of This Machine
Unauthorized uses include, but are not limited to, the
following:
• Transporting people on the machine or in the cab.
• Overloading the machine beyond its capacity.
Unauthorized Machine Modifications
• Do not perform any unauthorized machine
modifications.
Escape Tool
As a precaution, keep an escape tool in the cab.
NOTE: Inspect the escape tool periodically. Replace the
escape tool if it appears damaged or unable to
break the cab window for an emergency exit.
Fire Safety
Fuel, oil, and some engine coolants are flammable.
Observe the following:
• Keep open flames, airborne sparks, and burning
embers away from the machine.
• Shut down the engine and do not smoke when
refueling or servicing the machine.
• Add oil, fuel, or engine coolant in a well-ventilated
area.
• Clean up any spilled fluids immediately.
• Check the machine daily for debris buildup.
Electrical Fires
Short circuits, damaged wiring, or overcharging batteries
can cause fires. Observe the following:
• Check the wiring on the machine for damage when
doing a prestart check. Contact a SANY dealer to
repair or replace any damaged wiring.
• Make sure the battery is operating in its
recommended range.
• Never install aftermarket electrical equipment
without approval from a SANY dealer.