SANY SY60C, Руководство по эксплуатации и обслуживанию

Страница: 91 / 160

MACHINE OPERATION
4-27 SY60C Excavator OMM
0002912
Figure 4-62
If the machine is stuck and is unable to get out under its
own power, use wire rope(s) (2) attached to the frame (1)
to assist in its removal.
Towing Point for a Light Load
WARNING
• Make sure the equipment used for towing has the
correct capacity rating.
• A shackle must be used.
• Keep the wire ropes/slings horizontal and parallel
to the tracks.
• Drive the machine at low speed.
• Never use a broken chain, worn wire rope, or
bent hook to tow the machine.
• Never jerk the wire rope.
Failure to follow these warnings could result in
death or injury.
0002913
Figure 4-63
The machine is equipped with a towing point (1) on the
frame that can be used to tow a light load.
Recommended Operations
NOTICE!
• Avoid sudden stops when lowering the boom.
Hydraulic shock can damage the hydraulic
system.
• Avoid extending the arm cylinder while in full
travel. This can damage the hydraulic cylinder.
• Do not allow the bucket to come in contact with
the tracks when excavating at an angle.
• Do not allow the boom or arm hydraulic
cylinder’s hoses to come into contact with the
ground.
Operate the machine using the following applications.
The scope of application can also be expanded by using
various optional attachments.
Trenching Work
0002916
Figure 4-64
When performing trenching work, install a bucket that
matches the width of the trench, and keep the tracks
parallel with the trench.
When excavating a trench, always start from the sides,
then remove the earth in the middle.
Boom Swing Feature
0002918
Figure 4-65
The boom swing feature allows this excavator to perform
trench work close to a wall.
1
2
1