SANY SY60C, Руководство по эксплуатации и обслуживанию

Страница: 99 / 160

MACHINE OPERATION
4-35 SY60C Excavator OMM
Failure to follow these notices could cause
damage to the machine or cause it to operate
improperly.
12. Turn the battery disconnect switch to OFF.
13. Lock all doors and hoods.
14. Cover the exhaust opening to prevent contamination.
Securing the Machine
NOTICE!
To prevent damage to the machine during
transportation:
• Lower the radio antenna and position the
rearview mirror inward towards the cab.
• Secure any removed parts to the trailer.
• Put a wood block between the bucket cylinder
and the trailer floor to help prevent damage to the
bucket cylinder.
• Secure chains and wire ropes to the machine
frame.
• Prevent chains and wire ropes from crossing or
pressing against the hydraulic lines or hoses,
which could result in damage and leaks.
0002946
Figure 4-11
When the machine has been loaded, follow these
procedures to tie it down:
1. Prevent machine movement during transportation by
placing chocks (1) at both ends of the tracks.
2. Secure the machine firmly in place with chains or
wire ropes to prevent it from sliding.
Unloading the Machine
NOTICE!
• Use extreme care when the machine drives over
the joint area between the trailer and the ramps.
• Position the boom and arm at an angle between
90° and 110°.
• Do not unload the machine with the arm
retracted.
Failure to follow these notices could result in
damage to the machine.
1. Always load/unload the machine on firm, level
ground and keep a safe distance away from roads.
0002936
Figure 4-12
2. Park the trailer properly and place chocks (1) on the
trailer wheels. Place the ramps between the trailer
and the machine. Adjust the distance between ramps
to match the distance between the tracks.
3. Make sure the loading ramps have adequate width,
length, thickness, and strength. The maximum angle
of the ramps is 15° (2).
4. Remove the chains and wire ropes that secure the
machine.
5. Start the engine. See “Starting the Engine” on
page 4-12.
6. Push the hydraulic lockout lever to the unlock
position.
0002948
Figure 4-13
7. Raise the work equipment and retract the arm toward
the boom. Drive the machine slowly.
1
1
2
1