SANY SY60C, Руководство по эксплуатации и обслуживанию

Страница: 88 / 160

4-24
MACHINE OPERATION
SY60C Excavator OMM
Traveling on an Incline
Precautions When Traveling on an
Incline
WARNING
• Operating the machine on an incline may cause
the machine to become unstable.
• Use a lower engine speed when operating the
machine on an incline.
• Operate the machine slowly and monitor
machine movement.
• Do not travel on an incline with the bucket loaded
or with a lifted load.
• Do not swing a loaded bucket toward the
downhill direction.
Failure to follow these warnings could result in
death or serious injury.
NOTICE!
The engine may be damaged if the machine is
operated on an incline of more than 25°.
Tipping over may result if the machine is on uneven
ground or on a slope. To avoid such accidents, follow
these instructions:
• Keep the engine running at a low speed.
• Choose low-speed travel mode. See “Home Screen”
on page 3-5.
• Operate slowly and observe the motion of the
machine.
• Do not attempt to travel on a slope with the bucket
loaded or with a load lifted.
• Never attempt to travel up or down a slope with a
grade greater than 30°. Never attempt to cross a
slope with a grade greater than 15°.
• Always keep the seat belt fastened.
• Keep the bucket pointed toward the traveling
direction and

8 in.–12 in. (20 cm–30 cm) off the ground. Travel at
low speed.
• Do not attempt to change direction on a slope. Only
perform a direction change on an even and solid
surface.
• If the engine stalls on a slope, lower the bucket to
the ground immediately, neutralize all control levers,
and restart the engine. See “Engine Stalls on an
Incline” on page 4-25.
• Before traveling up a steep slope, allow the machine
to warm up sufficiently so it can perform well.
• Avoid crossing inclines as much as possible.
Slipping or rolling over may occur.
0002891
Figure 4-56
• Do not swing (1) the upper structure on a slope. The
machine may tip over. If such an operation is
necessary, swing the upper structure and the boom
with great care.
• Build a platform (2) on an incline so the machine can
be operated on a level surface.
0002902
Figure 4-57
• When traveling down a grade greater than 15°, the
work equipment should be positioned in front of the
cab. Keep the boom-arm angle between 90° and
110°, (3) and the bucket 8 in.–12 in. (20 cm–30 cm)
(4) above the ground.
0002904
Figure 4-58
2
1
3
4
6
5