SANKI P212, Инструкция по эксплуатации

Страница: 18 / 24

16/20
2) Parameter list
Each time the Vol ▲ key is pressed, the parameter display switches in the descending order of the
following table. Each time the Vol ▼ key is pressed, the parameter display switches in the ascending order.
No. Function Description Setting range
Default
value
Change during
operation
0C
Soft start
Output soft start timer
0.2-9.9
--: Invalid
-- ○
0d
Soft stop
Output soft stop timer
0.2-9.9
--: Invalid
-- ○
0L Remote Unit
setting oF: The remote unit is invalid.
on: The remote unit is valid.
oF/on oF ○
06
in1 setting in1 Input logic
hi: Operation with the
contact “Close”
Lo: Operation with
the contact “Open
hi ○
Version information Program version P2xx
Change during operation: 〇 … Enabled, … Disabled
13. Guard and Alert
1) Error display
If an error occurs, the error No. is displayed on the data display, and the output is stopped
forcedly.
Reset the error by either of the following methods (1) and (2).
When resetting the error, eliminate the abnormality beforehand.
If the external signal is an operation condition, be careful that the Controller becomes ready for
operation upon resetting.
(1) Power OFF the Controller, and the error will be reset.
(2) Press the Vol
▼ key and the Freq ▼ key together long for over 3 sec, and the error will
be reset.
Error No. Error name Contents
E-01 Overcurrent error The output is over the maximum output current.
E-02 Overvoltage error The output is over than the maximum output voltage.
E-10 Parameter error Memory error on startup
E-11 Operation data error Memory error on startup
E-12
System data error Memory error on startup
2) Alert display
When the Set key is pressed, an alert is displayed.
The output will not stop even during the operation.
If the Controller is continuously used as it is, an error may occur. Therefore, review the settings,
etc.
Alert No. Alert name Contents
E-81 Overvoltage alert The output voltage is the maximum.