SANKI P212, Инструкция по эксплуатации

Страница: 5 / 24

3/20
DANGER
・ Do not service the Controller in the Power-ON status. To avoid an electric shock, be sure to turn
OFF the power supply before starting the service.
・ Do not disassemble, remodel or repair the Controller, or an electric shock, a fire or injury could be
caused. For repair, ask the dealer.
・ Do not remove the front cover while the Controller is in the Power-ON status, or an electric
shock could be caused.
・ Do not put or insert anything in or into the Controller, or an electric shock or a fire could be
caused.
・ Do not use the Controller near explosive or flammable gas, or a fire could be caused.
・ Do not splash water or liquid, or an electric shock or a fire could be caused.
・ If smoke, odor or abnormal noise is emitted or other abnormality is detected, shut down the
Controller immediately. If the Controller is used in the abnormal status, a fire could be caused.
Contact the dealer.
・ If the Controller is not operated for a long time, shut down the Controller. If the Controller is left
live as it is, a fire could be caused.
・ Connect the power cable and the output cable as instructed in the Manual to avoid an electric
shock and a fire.
・ Do not forcedly bend, pull or pinch the power cable or the output cable, or an electric shock or a
fire could be caused.
・ Ground the earth terminal and the ground prescribed portions without fail, or an electric shock
could be caused. When working on grounding to a high position or a shaky stand, because fall or
tumble could be caused conditionally, take measures to prevent fall or tumble.
・ Do not conduct megger testing for any terminals other than the input terminal.
CAUTION
・ Do not use the Controller for an electromagnetic parts feeder or the like.
・ Do not turn ON/OFF the power supply frequently, or failure could be caused.
・ Do not start/stop the vibrator with an electromagnetic contactor or the like on the output side,
or failure could be caused.
・ Do not perform welding work on the feeder side in the Power-ON status.
・ Do not perform welding work on the feeder side when the feeder and the Controller are in the
connected status.
・ Do not remove the nameplate, the seal, or the like.
・ When installing the Controller, hold and fix it firmly and properly.
・ Do not transport or carry the Controller in the piled-up status, even in the packed status, or they
could fall, causing injury.
・ Do not place the Controller outdoors, in a humid place or in a place with excessive temperature
change.
・ Do not pile up the Controller two-tired or more, even in the packed status.
・ When disposing of the Controller, dispose it properly as general industrial waste.