Samyung BNW - 50, Руководство пользователя

Страница: 33 / 64

33
In addition, few things need to be taken into account when deciding where to install.
Microwave radiation can pass through the glass and nonmetallic walls, you must adjust the
microwave’s range so that it does not exceed the room limits. Otherwise the motion in the next room or
moving traffic along the outer side of the wall will cause the MW detector to trip.
Large reflective objects (especially metals) within the range may distort the patterns of the detective
range.
If two motion sensors are installed in the same room or on the opposite sides of a shared wall, the
sensors should not face each other and there must be at least 2 m distance between them.
6.5 Input terminal for remote activation( REMOT/TRAK)
Connect the ship’s heading or track control system to the remote activation input. Under the AUTO
mode, two brackets (INP+ / INP-) should be in contact for BNWAS to activate.
6.6 Additional reset terminal( RES2/LOW )
You can connect additional external reset unit or the motion sensors to this unit. By setting the display
unit, if ALARM A&B(one of the external alarm terminals) are used as Visual alarm (VIS) and Audible
alarm (AUD), this can be same as the standard reset unit. (Refer to 4.4.2 SETUP ALARM DEVICES)
6.7 Pulse reset set up( RES3/PULS)
Connect the additional equipment that could exist on the bridge in this input, where watch officer
could easily monitor. A high or low pulse will reset timer. You must be aware that periodic pulse signal
may automatically reset the timer.
6.8 NMEA Input ( NMEA/RXD )
You can connect the digital equipment which can output the NMEA data (reset, alert etc). Refer to the
chapter 11 NMEA (IEC 61162-1) interface section.
When digital equipment which can output the GPS data gets connected, there will be time shown on
the display.